saploading.netlify.com

x size of the area the nodes are in (in meters)

y size of the area the nodes are in (in meters)

z size of the area the nodes are in (in meters)

total number of hosts in the network

debug switch for core framework

send directly to the node or create separate gates for every connection

maximum sending power used for this network [mW]

minimum signal attenuation threshold [dBm]

minimum path loss coefficient

minimum carrier frequency of the channel [Hz]

should the maximum interference distance be displayed for each node?

debug switch for the base framework

use the playground as torus?

use a 2-dimensional world?

debug switch for the base framework

debug switch for the core framework

enable debugging for this module

Adds an offset to node addresses

x coordinate of the nodes' position (-1 = random)

y coordinate of the nodes' position (-1 = random)

z coordinate of the nodes' position (-1 = random)

length of the application message header (in bits)

stats switch

length of the network packet header (in bits)

debug switch

Honda d13 engine. length of the MAC packet header (in bits)

debug switch

collect statistics?

BMAC specific parametershow long is one slot?

how long is the check interval (CCA)?

should we animate the nodes with colors depending on their state or not?

bit rate

tx power [mW]

should mac send and expect acknowledgments?

maximum number of frame retransmissiononly used when usage of MAC acks is enabled

debug switch for core framework

enable/disable tracking of statistics (eg. cOutvectors)

defines the length of the phy header (/preamble)

Should transmission delay be simulated?

the strength of the thermal noise [dBm]

should thermal noise be considered?

Specification of the analogue models to use and their parameters

Specification of the decider to use and its parameters

The sensitivity of the physical layer [dBm]

The maximum transimission power of the physical layer [mW]

switchTimes [s]:

state the radio is initially in

radios gain factor (attenuation) while receiving

radios gain factor (attenuation) while not receiving

Number of available radio channels. Defaults to single channel radio.

Initial radio channel.

the number of different power consuming activities the phy layer haschange this parameter if your decider or physical layer uses morethan the default 5 activities (sleep, rx, tx, switching, decoding)

write per-activity and per-device statistics to omnetpp.sca(if false, only total energy and lifetime are written)

subscribe to battery status and record time seriesdata in omnetpp.vec (resolution depends on battery's publishDelta)

nominal battery capacity

battery capacity

nominal voltage

capacity is updated at least every resolution time

if > 0, capacity is published to the BB each publishTime interval

number of modules that will draw energy from the battery